• 全国中文核心期刊
  • 中国科技核心期刊
  • 美国工程索引(EI)收录期刊
  • Scopus数据库收录期刊
徐小丽, 高峰, 张志镇, 张传虎. 高温后花岗岩能量及结构效应研究[J]. 岩土工程学报, 2014, 36(5): 961-968. DOI: 10.11779/CJGE201405022
引用本文: 徐小丽, 高峰, 张志镇, 张传虎. 高温后花岗岩能量及结构效应研究[J]. 岩土工程学报, 2014, 36(5): 961-968. DOI: 10.11779/CJGE201405022
XU Xiao-li, GAO Feng, ZHANG Zhi-zhen, ZHANG Chuan-hu. Energy and structural effects of granite after high temperature[J]. Chinese Journal of Geotechnical Engineering, 2014, 36(5): 961-968. DOI: 10.11779/CJGE201405022
Citation: XU Xiao-li, GAO Feng, ZHANG Zhi-zhen, ZHANG Chuan-hu. Energy and structural effects of granite after high temperature[J]. Chinese Journal of Geotechnical Engineering, 2014, 36(5): 961-968. DOI: 10.11779/CJGE201405022

高温后花岗岩能量及结构效应研究

Energy and structural effects of granite after high temperature

  • 摘要: 利用MTS815电液伺服材料试验系统,研究了花岗岩在25℃~1000℃高温作用后的三轴压缩力学性能,基于D8 ADVANCE 型X射线衍射仪,研究了花岗岩经不同温度加热处理产物的物相特征。结果表明:①经历不同高温作用后,岩样三轴抗压强度、轴向峰值应变与围压呈非线性二次多项式增长关系,破坏应变能与围压呈线性增长关系。②岩样三轴抗压强度、破坏应变能随温度的升高先增大后减小,呈二次抛物线关系,400℃为最大值。③石英、长石、云母三者的最大衍射强度随温度的升高先增大后减小,400℃时达到最大,结合宏观力学试验,可以推断400℃为花岗岩的阀值温度。④石英在573℃发生由石英转变为石英的可逆反应;长石的差热曲线在700℃~900℃出现吸热谷,结构发生了由晶态向非晶态的相转变;在997℃时,云母矿物晶格破坏羟基逸出形成钠长石,这些因素共同作用使得岩样力学性能在400℃之后随着温度的升高而逐渐劣化。

     

    Abstract: The triaxial compression mechanical properties of granite under the action of temperature from 25℃ to 1000℃ are investigated by means of the MTS815 hydraulic pressure servo material experiment system. By use of a D8 ADVANCE X-ray diffractometer, X-ray powder diffraction analysis on heated granite is also made. The results show that: (1) The relationship among triaxial compressive strength, axial peak strain of granite and confining pressure after high temperatures is nonlinear quadratic polynomial growth. The failure strain energy of rock samples increases with the increase of the confining pressure significantly, that is, they exhibit a linear relationship. (2) The triaxial compressive strength and failure strain energy of rock samples show a parabola relationship with temperature, with the maximum value being 400℃. (3) Three maximum diffraction intensities of quartz, feldspar and mica increase as the temperature increases before 400℃, then decrease with increasing temperature, and reach the maximum value at 400℃. (4) For the quartz, reversible reaction from quartz into quartz at 573℃ occurs. The differential thermal curve of feldspar shows endothermic valley at 700℃ ~ 900℃, and the structure changes from crystalline phase to amorphous phase. At 997℃, the mineral lattice of mica is damaged, the hydroxy escapes and albite forms. The mechanical properties of rock samples gradually deteriorate as the temperature rises after 400℃ because of the above factors.

     

/

返回文章
返回